Milodon Water Pumps Bedienungsanleitung PDF herunterladen

MILODON

2250 Agate Court, Simi Valley, Ca 93065

(805) 577-5950

INSTALLING YOUR WATER PUMP CORRECTLY

Follow the simple step-by-step instructions below. Handle your new water pump with care. Never strike shaft.

This can damage shaft seal or bearings. Always check fan pulleys, belts and fan clutch when installing new water

pump.

With Milodon High Volume water pumps, a Milodon High Flow thermostat will allow the water pump to work

to its full potenial. The opening of standard thermostats may also be delayed due to the increased pressure of the

higher effeciency Milodon water pump.

1. Flush cooling system if it shows signs of corrosion. Clean pump impeller cavity and gasket surface

completely. On Ford water pumps follow back plate installation instructions on the pump.

2. Position new gaskets after coating them on both sides with sealer.

3. Carefully install new pump. Do NOT strike the shaft as this may crack the impeller seal resulting in an

immediate leak. Tighten bolts using a cross pattern.

4. Turn pump shaft by hand to check for free rotation.

5. Check thermostat, radiator cap and replace if they show signs of sticking or leaking. Connect hoses.

6. Check fan blade for cracks, bent blades, loose rivets, etc. Never straighten a heavily damaged fan blade.

When any defects are found replace the entire fan.

7. If a clutch fan is used, look for loss of oil or wobble.

8. Check that the fan pulley sits square on pump hub. Using lockwashers, torque bolts evenly to assure wobble-

free operation. A misaligned or wobbling fan will damage the water pump and void the warranty.

9. Rotate fan by hand and check for fan wobble - 3/32" max. at outer edge (with no fan clutch) 1/4" max with

fan clutch.

10. Check belts for cracks, frayed edges, missing sections. A new belt is always best.

11. Adjust belts to proper tension. Lay straight edge between alternator and pump pulley and adjust belt

deflection to 1/2" to ¾”. Excessive belt tension WILL take out the water pump bearings and will void the

warranty. More is not better here. Recheck after ½ hour of operation. As a new belt works in it will strech

some and the initial belt tension will loosen.

12. Check fan clearances at blade tip, between fan and shroud and fan and radiator. Check that motor mounts are

tight and in good shape as engine twist during acceleration will move the fan into the shroud.

13. Fill cooling system and check for leaks.

1 2

MILODON 2250 Agate Court, Simi Valley, Ca 93065 (805) 577-5950 INSTALLING YOUR WATER PUMP CORRECTLY Follow the simple step-by-step instructions belo

Seite 2

14. Start engine and run until normal operating temperature is reached. Check for leaks and for smooth operation. Never stand in line with the fan o

Keine Kommentare

Milodon Water Pumps Bedienungsanleitung